Uninterruptible power supply testing

A UPS is expected to support critical equipment when mains power fails, so its condition must be checked before that event occurs. Electrical Testing Services (ETS) tests defined operating inputs and visible system condition within its confirmed service scope.

1300 30 49 59

Request a quote

We'll come back with a clear scope and next step.

Or call 1300 30 49 59

Confirm your UPS is ready for a power interruption

Uninterruptible power supplies provide short-term power while equipment shuts down safely or an alternative supply becomes available. They can also condition the supply and reduce exposure to some voltage disturbances. Testing helps identify obvious input, battery or operating issues that may prevent the unit performing as expected. The required depth of testing depends on the UPS type, size and critical load.

Uninterruptible power supply testing

What UPS testing can cover

Checking input voltage

Checking input frequency

Inspecting accessible battery condition

Reviewing visible alarms and operating status

Checking accessible cables, connections and ventilation

Recording the unit and test findings

Identifying systems requiring specialist maintenance or further testing

Equipment that relies on UPS protection

UPS systems commonly support computers, servers, communications, control equipment and other electronics that cannot tolerate an abrupt loss of power. Larger units may protect critical systems across a facility. The testing scope should reflect the operational consequence of failure and the equipment connected to the unit.

Testing results and maintenance planning

Findings can identify batteries, alarms or input conditions that require attention. The report gives the responsible team a basis for arranging specialist servicing or replacement. Runtime testing, load-bank testing, installation and repair should only be included where the agreed ETS scope confirms those services.

Why businesses rely on ETS for safety and compliance

Qualified technicians working to consistent standards

ETS technicians follow the agreed UPS inspection and testing procedure using suitable instruments. The work remains within the confirmed capability for the unit and site.

Specialist technical personnel

Complex UPS systems may require manufacturer or specialist power-system support. ETS identifies when findings should be escalated beyond the initial testing scope.

Clear reporting and asset records

The unit, operating observations and measured inputs are recorded so the facility team can plan follow-up work.

NATA accreditation and certified systems

ETS operates under NATA accreditation for applicable inspection activities and maintains certified management systems for quality, safety and environmental performance.

Experience managing services at scale since 2002

ETS has supported electrical testing programs since 2002. UPS checks can be coordinated with broader site testing where appropriate.

Electrical testing services across Australia

ETS has offices and strategically located personnel throughout Australia. The team supports individual properties, regional programs and national portfolios through one service provider.

New South Wales:Sydney, Newcastle, Wollongong and Broken Hill
Western Australia:Perth, Geraldton, Broome, Port Hedland and Kununurra
South Australia:Adelaide
Tasmania:Hobart
Northern Territory:Darwin and Alice Springs
Australian Capital Territory:Canberra

Arrange UPS checks with ETS to prepare for any future power interruptions that may occur

Identify the UPS units, connected loads and critical operating requirements at the site. ETS can confirm the available testing scope and plan the visit around systems that cannot be taken offline without preparation.